Aside from the Heater and Tank alone, for a complete setup you will need to a ‘Class A’ Chimney, barometric damper, and capped clean-out tee. All of these are available from Lanair and featured in some of our value packages. Some people have these installed already, so we offer the Heater and Tank on their own, but in most cases people require ‘everything’ for a fresh install. To get the majority of your needs met in one place, we’d highly recommend a value package, we introduced them specifically to make it easier on the customer.

You will also need:
* A primary air regulator.
* A secondary source of air 2 CFM 60 PSI ( reduced at unit ).
* Electrical dedicated circuit ( this will be a hard-wired install ).

* Refer to your owner’s manual and installation diagrams:
‘Class A’ chimney is rated for 1900 degrees F. The barometric damper equalizes pressure between the inside of the building & exhaust gases allowing you to adjust exhaust draft for proper flame. This insures exhaust gases exit the chimney properly.